KCB Manual of series double / monostable magnetic switch
一、Summary
The inductor is mainly used for elevator leveling and speed changing, and can also be used for limit control of other lifts. It has a high cost performance ratio. Due to the use of imported high-sensitivity reed tube and non-contact induction working mode, it overcomes the defect of mechanical switch easy to be damaged. It has the advantages of sensitivity, reliability, long service life, quick breaking, no power consumption, convenient installation and wiring and reasonable structure.
二、Technical index
1 | Contact rating: | 100mA/48V |
2 | Frequency of use: | 100Hz |
3 | Shock resistance (11ms): | 50g |
4 | Repeat positioning accuracy: | 0.1mm |
5 | Use of temperature: | -20℃-60℃ |
6 | Contact life: | 1000万次 |
7 | Protection level | IP67 |
三、Dimensions
四、 Debugging methods and precautions:
1. fix the product to the mounting bracket.
2. magnetic strip attached to guide rail
3. magnetic strip and sensor distance in the range of 5-20, not too far. Prevent the magnetic rate from causing the switch instability.
Note: the output line of the device must not be directly connected to the power supply to cause short circuit, which may cause permanent damage.
At any time to avoid magnets close to 100℃ above high temperature, lest demagnetization; the resulting personal and equipment losses are not responsible for the company.
五、 Accessories
two rubber strips :80*20*12 2 mounting bracket :1 set (customer request, default mismatch)